1 Flute Down-Cut Router

Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

  • Right hand cut, left hand helix, spiral O-flute.
  • For cutting soft and hard plastics, laminated materials, and solid surface materials.
  • Chips are pushed down.
  • Space required between materal and machine table for chip ejection.
  • Burr free finish at top of cut.

Standard Sizes (inch)
SHK Ø CED LOC OAL PART #
1/8" 1/8" 1/4" 2" R1D-125-125-250
1/8" 3/8" 2" R1D-125-125-375
3/16" 3/16" 5/8" 2" R1D-187-187-625
1/4" 1/8" 1/2" 2" R1D-250-125-500
3/16" 5/8" 2" R1D-250-187-625
1/4" 3/4" 3" R1D-250-250-750
1/4" 1-1/4" 3" R1D-250-250-1250
3/8" 3/8" 5/8" 2" R1D-375-375-625
3/8" 1-1/8" 3" R1D-375-375-1125
3/8" 1-5/8" 3" R1D-375-375-1625


Mertic Sizes (mm)
SHK Ø CED LOC OAL PART #
3 mm 1.5 mm 4 mm 38 mm R1A-3-1.5-4
2 mm 5 mm 38 mm R1A-3-2-5
2.5 mm 6 mm 38 mm R1A-3-2.5-6
3 mm 8 mm 38 mm R1A-3-3-8
4 mm 4 mm 12 mm 50 mm R1A-4-4-12
5 mm 5 mm 16 mm 50 mm R1A-5-5-16
6 mm 4 mm 10 mm 50 mm R1A-6-4-10
5 mm 12 mm 50 mm R1A-6-5-12
6 mm 16 mm 50 mm R1A-6-6-16
8 mm 8 mm 20 mm 63 mm R1A-8-8-20
10 mm 10 mm 25 mm 76 mm R1A-10-10-23

 

SHK Ø = Shank Diameter CED = Cutting Edge Diameter (Tip Width)
LOC = Length of Cut OAL = Overall Length